Installation guide

if the appliance is used in a new branch
circuit installation (1996 NEC), mobile home,
recreational vehicle, or where local codes DO
NOT permit grounding through the neutraJ
(white) wire, the appliance frame MUST NOT
be connected to the neutral wire of the 4-wire
electrical system.
Your appliance has a 3-wire cabJe to be connected
to a 4-wire grounded junction box (see figure 6):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. Cap the white wire from the power supply cable if a
3-wire appliance cable is supplied.
4. In the circuit breaker, fuse box or junction box:
Connect appliance and power supply cable wires as
shown in figure 6.
GroundWire
Red
Wires
Cablefrom PowerSupply
Wire
Black
Wires
Ground Wire
(Bareor
GreenWire)
Box
U.L.-Listed
Conduit
Connector (or
CSA listed)
Cablefrom appliance
Figure 6
4-WIRE GROUNDED JUNCTION BOX
Your appliance has a 4-wire cable to be connected
to a 4-wire grounded junction box (see figure 7):
1. Disconnect the power supply.
2. In the junction box:
Connect appliance and power supply cable wires as
shown in Figure 7.
Ground
Wire
\
Red
GroundWire
(Bareor
GreenWire)
JunctionBox _......
CablefromPowerSupply
Wires
Black
U.L.-ListedConduit
Connector(orCSAlisted)
Cablefromappliance
Figure 7
4-WIRE GROUNDED JUNCTION BOX