Manual

Electrical information
These guidelines must be fo!lowed to ensure that safety
mechanisms in the design of this freezer will operate properly.
Avoid fire hazard or
electric shock. Do not
use an extension cord
or an adapter plug. Do
not remove any prong
from power cord.
Grounding type
wall receptacle
Do not under "_
any circumstances
cut, remove,
or bypass
the grounding prong
from this plug. j
Power supply
cord with 3-prong
grounding plug
• Refer to the serial plate for correct electrical rating. The
power cord of the freezer is equipped with a three-prong
grounding plug for protection against shock hazards. It must be
plugged directly into its own properly grounded three-prong
receptacle, protected with a 15 amp time delay fuse or circuit
breaker. The receptacle must be installed in accordance with
the local codes and ordinances. Consult a qualified electrician.
Receptacles with Ground Fault Circuit interrupters (GFCl) are
NOT RECOMMENDED. DO NOT USE AN EXTENSION CORD OR
AN ADAPTERPLUG.
• If the voltage varies by 10 percent or more, freezer performance
may be affected. Operating the freezer with insufficient power
can damage the motor. Such damage is not covered under the
warranty. If you suspect your voltage is high or low, consult your
power company for testing.
• To prevent the freezer from being turned off accidentally, do not
plug the unit into an outlet controlled by a wall switch or pull cord.
• Do not pinch, knot, or bend the power cord in any manner.
r!_v,v_.1,i_ll#B
Other Precautions
• To defrost, always unplug unit first.
• Never unplug the freezer by pulling on the power cord. Always
grip the plug firmly and pull straight out from the receptacle.
• Turning the control to "OFF" turns off the compressor but does
not disconnect power to other electrical components.
First Steps
Before starting the freezer, follow these important first steps.
Installation / Freezer Placement
• Choose a place that is near a grounded electrical outlet.
• The freezer should be located where surrounding temperature
will not exceed 11O°F (43°C). Temperatures of 32°F (O°C) and
below will NOT affect freezer operation. Additional compressor
heaters are not recommended.
• Allow space around the unit for good air circulation. Leave a 3
inch (75mm) space on all sides of the freezer for adequate
circulation.
3" AIR SPACE
Installation
Leveling
The freezer must have all bottom corners resting firmly on a solid
floor. The floor must be strong enough to support a fully loaded
freezer. It is VERY IMPORTANT for your freezer to be level in order
to function properly. If the freezer is not leveled during installation,
the door/lid may be misaligned and not close or seal properly,
causing cooling, frost or moisture problems.
To level Upright Units:
After discarding crating screws and wood base, use a carpenter's
level to level the freezer from front to back. Adjust the plastic
leveling feet in front, ½ bubble higher, so that the door closes easily
when left halfway open.
To level Chest Units:
If needed, add metal or wood shims between feet pads and floor.
CRATING
SCREW
""- DISCARD THE (4) CRATING
SCREWS AND {2) WOOD BASES
Unpacking and Leveling - Upright Freezers
_[_ To allow door to
close and seal properly, DO NOT let
food packages extend past the front
of shelves,
Shelf Front .........................................