Wiring Diagram

Test
Number
Problem
Solution
Test 7
Fills with wrong temperature water.
- Turn both faucets fully.
-Make sure the temperature selection is correct.
-Make sure the hoses are connected to the correct faucets.
Flush water lines.
-Disconnect the hoses and clean the screens. The hose filter
screens may be clogged.
Test 8
Load is too wet at the end of the cycle.
- Use high efficiency detergent to reduce over-sudsing.
-The load is too small. Very small loads (one or two items) may
and .cause imbalance incomplete spin
Test 9
Leaks water.
-
are tight.
-
-
Make sure that all the hose connections
Make sure that the end of the drain hoseis correctly inserted and
secured to the drainage system.
Avoid overloading.
Use high eciency detergent to prevent over-sudsing.-
Test 10
Has excessive suds.
-
-
-
Use high eciency detergent to prevent over-sudsing.
Reduce the detergent amount for soft water, small or lightly soiled
loads.
Non-HE detergent is NOT recom-mended.
Test 11
Has an order.
-
-
-
Run a Tub Clean cycle to clean the tub and basket periodically.
Check the detergent. Excessive suds collect in nooks and
crannies and cause mold.
Dry the interior of the washer after the total cycle has finished.
5
Troubleshooting
Tests
Washer Troubleshooting Tests, continued