Installation guide

Connecting drain hose to washer
Inspect rubber flap on pump outlet. Ensure it is in
place and not folded under or torn.
1 With the spring clamp already installed, place
the drain hose elbow over the pump outlet at the
lower rear of the washer. Ensure the hose elbow is
completely and squarely seated to the pump outlet
before using pliers to move the spring clamp into
place.
J
DRAIN PUHP
OUTLET
SLIDE CLAHP
TO HERE
\
SPRING CLAHP
2 "Thread" the end of the drain hose up through
either of the outer, larger "D" ring retainers below
the top panel.
3 Locate the anti-siphon ring shipped with your
washer. Place it over the end of the drain hose and
slide it past the first ring of "accordion" ribs.
ANTI-SIPHON
"._ DISC