Installation Instructions

INSTALLATION INSTRUCTIONS

Water connection, continued (Steam Model only)

WATER INLET

ON DRYER

DIRECT CONNECTION

OR WITH EXTENSION*

COLD WATER SUPPLY

HOSE TO WASHER

5 If your installation has room for the COLD water

supply to accept the “Y” connector directly, thread

the “Y” connector to the COLD water supply and

snug it by hand; then tighten it another 2/3 turn

with pliers.

6 If there is not room to install the “Y” connector

directly, thread a short extension hose on to the

COLD water supply and snug it by hand; then

tighten it another 2/3 turn with pliers.

*Laundry hose extension not included with dryer.

7 Thread the “Y” connector to the short extension

hose and snug it by hand; then tighten it another

2/3 turn with pliers.

8 Connect the COLD inlet hose for the washer to the

“Y” connector and snug it by hand; then tighten it

another 2/3 turn with pliers.

9 Connect the straight end of the long hose from the

kit to the other outlet on the “Y” connector and

snug it by hand. Connect the hose’s 90° coupling to

the brass water inlet on the back of the dryer and

snug it by hand. Tighten each connection of the

dryer inlet hose another 2/3 turn with pliers.

10 Turn on the water and check for leaks at all

connections.

NOTE

If you were able to install the “Y” connector directly to

the COLD water supply, please skip to step 8.

NOTE

Short extension available from your local hardware

supplier. Extension hose must meet qualiﬁ cations for

use in laundry installation.