Use and care guide

Operating Instructions

(continued)

CHECK FILTER FEATURE, YOU WILL SEE:

DO THIS:

PRESS FILTER

RESET BUTTON

TIMER: DELAY STOP / START FEATURE YOU WILL SEE HOW MUCH TIME IS CHOSEN:

Note: For Delay Stop, the unit must be in the On position．

Note: For Delay Start, the unit must be in the Off position.

FIRST

DO THIS:

PRESS

TIMER BUTTON

THEN

DO THIS:

Note: This feature is a reminder to clean the Air Filter (See

Care and Cleaning) for more efficient operation. The LED

(light) will illuminate after 250 hours of operation. To reset

after cleaning the filter, press the "Filter Reset" button and

the light will go off.

If the display reads "AS" , a sensor has failed. Contact your

Authorized Frigidaire Service Center.

If the display reads "ES" , a sensor has failed. Contact your

Authorized Frigidaire Service Center.

FAULT CODES:

First, Press TIMER button, then adjust timer setting, tap or

hold the UP arrow ( ) or the DOWN arrow ( ) to

change delay timer at 0.5 hour increments, up to 10 hours,

then at 1 hour increments up to 24 hours. The control will

count down the time remaining until start (8, 7.5, 7, etc.).

The Delay Start Operation automatically selects cooling with

maximum Fan speed (if Cool, Energy Saver, or Fan Only was

the last mode selected) . The temperature maintained will

be the same as previously set. To change the set tempera-

ture, press "COOL" then Up or Down arrows until the de-

sired temperature is indicated on the display. After 5 se-

conds, the control will automatically change the display back

to the hours remaining until the unit will start/stop. Pressing

the unit On/Off button at any time will cancel the Delay

Start/Stop function. The Delay Start/Stop Feature will work

until the unit either starts or stops. Once that happens the

above steps have to be repeated again.

PRESS

UP/DOWN

SET BUTTONS