Manual

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire room air conditioner

Operating Instructions

(continued)

REMOTE SENSING FEATURE

(on some models):

,MP_J.,,

=_I DO THIS:PRESS REMOTE

SENSING

_Z!_::_|START BUTTON

clean

air

LIGHT pulsing ( On & Off intermittently ),

econ sensing

#n only

timer MODE V ON-OFF A

NOTE: Unit display shows the set temperature

Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode,

NOTE: Remote display

is actual temperature

at remote control only

To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button, Next, use

the" A V "buttons to set the desired temperature at the remote, {Note that the set temperature will only be displayed on the unit

itself ), The LIGHT on the unit control will pulse to indicate it received the signal, The LIGHT on the remote control will pulse each time it

sends a signal, It will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button, If the unit

does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has

ended, The display on the remote control indicates the temperature at the remote ONLY,

NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the

unit,

FAULT CODES:

ON-OFF

auto l

_ m_ " filter

to reset

A FAN SPEED steep

If the display reads "AS", a sensor has failed. Contact your

Authorized Frigidaire Service Center.

TO CHANGE TEMPERATURE DISPLAY:

L temp/timer . "}

_ Z ° J reset

ON-OFF A FAN SPEED steep

I " /DO THIS:

PRESS AND HOLD THE

UP/DOWN BUTTONS

TOGETHER FOR 3 SECONDS

YOU WILL SEE:

temp/timer

ON-OFF

auto l

c _ mh_" filter

to reset

A FAN SPEED sleep

Note: The control is capable of displaying temperature in

degrees Fahrenheit or degrees Celsius.