Installation guide

Tosecurelowersashinplace,attachrightanglesashlockwith1/2"(12.7mm)screwasshown(FIG.10).
NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by
window itself.
Cut foam window seal and insert it into the space between the upper and lower sashes (FIG. tl).
FIG. 10 FIG. 11
Check that air conditioner is tilted back about 1/4" to 1/2" (tilted about 2° to 4 ° downward to the outside, see
FIG. 12A& FIG. 12B). After proper installation, condensate should not drain from the overflow drain hole during
normal use, correct the slope otherwise.
INSID_ OUTSIDE '
FIG. 12B
H÷
INSIDE ....................q OUTSIDE
__L
H--'T_ .... _"Botto m Rail
about I
1J4" 1J2"I 1
Wooden Window
_H=H1-H2 about 1/4"~1/2 ,'
A .,L
HI-_[__]H2t r_Bottom Rail
Vinyl-Clad Window
Trim the weather seal (6"X3/4"X1/12") with a proper length,
peel off the protective backing and plug any gaps if needed ill/ FIG. 13 /i
as shown FIG.13.
Removing the air conditioner From Window
Turn the air conditioner off, and disconnect power cord.
Remove sash seal from between windows, and unscrew sash lock.
Remove screws installed through frame and framelock. _... -.__ ....
• Close (slide) side panels into frame. (iii I _
Keeping a firm grip on air conditioner, raise sash and
carefully remove.
Be careful not to spill any condensate water while lifting
unit from window. Store parts WITH air conditioner.