Manual
Operating Instructions
(continued)
TO TURN UNIT OFF:
mote _ F . []
_nsi_g _ h_ fitter
1o reset
[ V ON-OFF A FAN SPEED steep
I\ DO THIS:
PRESS
ON/OFF BUTTON
YOU WILL SEE:
lo .ON-OFF A FAN SPEED
fitter
reset
steep
Note: If the unit is turned off in heat mode (if applicable) or
fan only mode, it will return to the same setting when it is
turned on again, When the unit is turned off in cool or energy
saver(econ) mode, it will run in energy saver(econ) mode
when it is turned on again, but the setting of temperature
and fan speed will remain.
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with.
• The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. /_
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue
to run during this time.
• There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility of having
to roll through to select another mode,
The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees.
After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
Fresh Air Vent Control (on some models)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (see Fig, t)
2. Draw fresh air into the room - Fresh Air (see Fig, 2)
3. Exchange air from the room - Vent Open (see Fig. 3)
Figure i (VENT CLOSED)
Figure 2 (FRESH AIR)
Figure 3 (VENT OPEN)
AUGER WHEELS
[
(8-WAY)
Air Directional Louvers
Air directional louvers control air flow direction. Your air conditioner has the louver
type described below.
Auger Type
The louvers will allow you to direct the air flow Up or Down and Left or Right
throughout the room as needed, Rotate the Auger Wheels until the desired
Left/Right direction is obtained, Pivot horizontal louvers until the desired
Up/Down direction is obtained,