Installation guide

Leveling your laundry center
Excessive noise and vibration can be prevented by
properly leveling the laundry center,
1 With the laundry center within 4 feet (1 m) of its
final location, place a level on top of the washer lid,
2 Use adjustable pliers to adjust the leveling legs so
the laundry center is level front-to-rear and side-to-
side, and stable corner-to-corner,
3 Pressdown on alternate corners and sides and feel
for the slightest movement. Adjust the appropriate
leg(s) so the laundry center sits solidly on the floor
on ALL four legs, Keep the leveling leg extension at
a minimum for best performance of the washer.
Connecting inlet water
1 Run some water from the hot and cold faucets
to flush the water lines and remove particles
that might clog the water valve screens and to
determine which faucet is hot and which is cold
supply,
RUBBERWASHERS
MUST BE PRESENT
USE ONLY
NEW HOSES
Hoses are not included with laundry center purchase.
See "Accessories" section for various inlet hose kits to
fit your specific installation,
2 Connect the HOT inlet hose to the HOT inlet
connection on the washer and the COLD inlet
hose to the COLD inlet connection on the washer.
Tighten by hand until snug. Then tighten each
supply connection another 2/3 turn with pliers.
Do not cross thread or over=tighten these
connections.
3 Connect the HOT inlet hose to the HOT water
supply and the COLD inlet hose to the COLD water
supply. Tighten by hand until snug, Then tighten
each supply connection another 2/3 turn with
pliers, Do not bendr kink or pinch water inlet
hoses.
4 Turn on the water and check for leaks,
(HOT)
d