Manual
Table Of Contents
17
DRYER OPERATING INSTRUCTIONS
Drying Cycle Settings
Drying Temperature (Dry Temp)
Select the temperature setting most suitable
for each load. To protect your fabrics, not all
temperatures are available with every cycle. If
an unavailable temperature setting is selected
by the user, the nearest available temperature
will be substituted.
High
Recommended for durable fabrics and towels.
Normal
Recommended for most cotton fabrics.
Low
Recommended for delicate fabrics.
Drying Cycle Indicator Lights
The drying cycle indicator lights provide
information during the dry cycle.
The Close Dryer Door
advisory LED will illumi-
nate if the dryer door
is open. Fully close the
dryer door before start-
ing the dryer. The dryer
will not operate with
the door open.
The Clean Lint LED
will illuminate after
each drying cycle as a reminder to clean the
lint lter. The lint lter must be cleaned
after every load. This is NOT a warning of
a clogged exhaust duct or lter. Open door
or press CANCEL to turn off the LED.
The cycle status lights will illuminate as
each stage of the drying cycle is reached.
Stages include: Drying, Cooling, and Done.
Drying Cycle Controls
(Start, Pause, and Cancel)
START
Press DRYER START|PAUSE
button once to begin the dry-
ing cycle. The unit will emit
one beep before the drum
begins to rotate.
Dryer Setting Chart
These temperatures and water levels are available with the following cycles
Quick Dry
(25 min)
Delicates
(Auto dry)
Activewear
(Auto dry)
Normal
(Auto dry)
Bulky
(Auto dry)
Air Fluff - no heat
(30 min)
90 min
60 min
30 min
15 min
Dry Temp (Temperature)
High
Normal
Low
= Available selections.
= Factory presets. = Non-modifiable presets.
PAUSE
Press DRYER START|PAUSE button while
the dryer is running to pause the drying cycle.
Opening the door with a cycle running will also
pause the cycle. You will hear two beeps. Al-
low the drum to come to a complete stop
before reaching inside. Press the DRYER
START|PAUSE button while paused to restart
the drying cycle.
CANCEL
Press the DRYER CANCEL button to cancel the
drying cycle. Wait for the drum to come to a
complete stop before reaching inside.
NOTE
Air Fluff setting does not use heat and WILL
NOT illuminate any of the Dry Temp LED
lights.