Owner's Manual

CAUTION

Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.

Door Handle Mounting

Instructions for Frigidaire

Professional

1 Remove handles from carton and any

other protective packaging.

2 Position fresh food handle end

over upper and lower pre-installed

shoulder bolts (A) that are fastened

into door, ensuring the holes for the

set screws are facing towards the

opposite door.

3 Whileholdinghandlermlyagainst

door, fasten upper and lower Allen set

screws (B) with supplied Allen wrench.

4 Repeat steps 2 and 3 to install

opposite handle. Ensure the holes for

the set screws are facing towards the

rstdoor.

5 Position freezer handle end over

left and right pre-installed handle

mounts that are fastened to the

door, ensuring the holes for the set

screws are facing down.

6 Whileholdinghandlermlyagainst

door, loosely tighten far right Allen

set screw (B) with supplied Allen

wrench until there is no gap between

handle and door.

7 Stillholdingthehandlermlytothe

door,rmlytightenfarleftAllenset

screw (B) with supplied Allen wrench.

8 Return to the far right Allen set

screw(B)andrmlytightenwith

supplied Allen wrench.

9 Firmly tighten the inside Allen set screws.

INSTALLING DOOR HANDLES



NOTE

All set screws should be tightened so the screw is below the surface of the handle. The handles

should be drawn tight to freezer and refrigerator doors with no gaps. Opening the opposite door

while tightening the Allen screw makes installation easier.

The door handle may loosen over time or if it was installed improperly. If this happens, tighten the

set screws on the handles.

Mounting Refrigerator Handles

Mounting Freezer Handle