Manual

CLEANING VARIOUS PARTS OF YOUR COOl{TOP
Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is COOL. REMOVE
SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANING WILL REDUCETHE NUMBER OF
MAJOR CLEANING LATER.
Aluminum (Trim Pieces) & Use hot, soapy water and a cloth. Dry with a clean cloth.
Vinyl
Glass, Painted and Plastic Using a soft cloth, clean with mild dish detergent and water or a 50/50 solution of
Control Knobs, Body vinegar and water. Follow by rinsing the area with clean water; dry and polish with a
Pieces, and Decorative soft cloth. Glass cleaners may be used if sprayed on a soft cloth first. DO NOT spray
Trim liquids directly on the control pad and display area. Do not use large amounts of
water on the control panel - excess water on the control area may cause damage to
the appliance. Do not use other liquid cleaners, abrasive cleaners, scouring pads, or
some paper towels - they will damage the finish.
Control Panel Wipe the control panel clean after each use. Before cleaning the control panel, turn
all controls to OFF and remove the control knobs. To remove, pull each knob straight
off the shaft. Clean using hot, soapy water and a cloth. Be sure to squeeze excess
water from the cloth before wiping the panel; especially when wiping around the
controls. Excess water in or around the controls may cause damage to the appliance.
To replace knobs after cleaning, line up the fiat sides of both the knob and the shaft;
then push the knob into place.
Stainless Steel, Chrome Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water
Decorative Trim (some and a cloth. Do not use cleaners with high concentrations of chlorides or
models) chlorine. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are
especially made for cleaning stainless steel. Always be sure to rinse the cleaners
from the surface as bluish stains may occur during heating that cannot be removed.
; Porcelain Enamel
Burner Grates, Burner Rings
(some models), Cooktop
Surface (some models)
ii
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a
1:1 solution of clear water and ammonia. If necessary, cover difficult spots with
an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and
a damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry
with a clean cloth or paper towel. Remove all cleaners or the porcelain may become
.......damaged during future heating: DO NOT use sPray oven cleaners on the cooktop.
CLEANING TilE COOk'TOPr BURNER CAPS
& GRATES
The cooktop is designed to make cleaning easier. Because
the gas Burners are sealed, cleanups are easy when
spillovers are cleaned up immediately.
The cooktop, Burner Heads and Caps should be routinely
cleaned. Keeping the Burner Head Ports clean will
prevent improper ignition and an uneven flame. Refer to
the following instructions:
THE COOk'TOP IS NOT REMOVABLE. Do not
attempt to remove or lift the cooktop.
Pay attention to not damage electrodes. Damaged
electrodes may cause a delayed ignition or prevent the
Any additions, changes or conversions required in order
for this appliance to perform satisfactorily must be
made by an authorized Service Center.