Use and Care Manual

6
FIRST STEPS
Lid Removal (chest models)
See Instructions on hinge label. Unplug the unit.
Door Removal (upright models)
If door must be removed, unplug the unit.
1. Gently lay the unit on its back, on a rug
or blanket.
2. Remove 2 base screws and base panel.
3. Remove wire from clips on bottom of
cabinet if required.
4. Unplug connector, if required, by holding
the cabinet connector in place, and pulling
door connector out.
5. Remove bottom hinge screws.
6. Remove plastic top hinge cover.
7. Remove screws from top hinge.
8. Remove top hinge from cabinet.
9. Remove door and bottom hinge
from cabinet.
10. To replace door, reverse the above order
and securely tighten all screws to prevent
hinge slippage.
Base Panel
Screws
Hinge Screws
Wire
Cabinet Connector
Base
Panel
Door Connector
Clips
3. Once the inside surface snaps in place,
continue the process by rolling the handle
clip slightly outward and pressing down
rmly to snap onto the outside surface. If
installed incorrectly, the handle clip will not
lay at.