Use and Care Guide

5
OPERATING INSTRUCTIONS
Option Selections
Sanitize Option
To sanitize your dishes and glassware, select
SANITIZE option. When selected, the light
above the pad will come on and remain on until
end of cycle. The water temperature in the
nal rinse will be raised to 155
o
F (68
o
C) and will
maintain that temperature for 9 minutes. This
option is available in Heavy and Normal Cycles.
Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing
action will continue during the water heating
delay. For best results, the incoming water
temperature should be at least 120
o
F (49
o
C).
The sanitize criteria may not be satised if
there is an interruption of the cycle, power
failure or if the incoming water temperature is
below 120
o
F (49
o
C).
To turn o the SANITIZE option, press the pad a
second time. The light above the pad will turn o.
High Temp Wash Option
When HI-TEMP WASH option is selected, the
dishwasher heats water in the main wash to
approximately 140
o
F (60
o
C).
This increase in water temperature helps the
dishwasher detergent remove food grease
and soil from dishes more eectively and
aids in improved drying performance. HIGH
TEMP WASH option can be used with all cycles
except RINSE ONLY. HIGH TEMP WASH is
automatically provided when the HEAVY WASH
cycle is selected.
When HIGH TEMP WASH option is selected, the
light above the pad will come on and remain on
until end of cycle. To turn o the HIGH TEMP
WASH option, press the pad a second time.
The light above the pad will turn o.
NOTE
Not all cycles and options available on all
models.

Heat Dry
The HEAT DRY option in combination with rinse
aid will enhance drying performance. The
energy required to use the HEAT DRY option
costs pennies per cycle; however you will
have items in your dish load that will not be
completely dry at the end of the cycle.
Child Lock Controls
To prevent children from accidently changing
the dishwasher cycle or starting the dishwasher,
lock the dishwasher controls by pressing the
OPTIONS pad for 3 seconds while the door is
latched. An indicator light on the lock graphic
pad will illuminate when the controls are locked
and no new selections can be made until the
lock is released. To unlock the controls, press
the same pad, OPTIONS, again for 3 seconds
until the indicator light goes out.
Status Indicator Lights
When the SANITIZE option is selected, the
SANITIZED light will glow when the SANITIZE
cycle is nished. If the dishwasher did not
properly sanitize the dishes, the light will not
come on. This can happen if the cycle is
interrupted. The light will remain on until the
door is opened.
The CLEAN light will come on at the end of
cycle and remain on until the door is opened.
Delay Start
The DELAY START option allows you to
automatically delay starting your dishwasher for
4 hours.
To activate delay start option for 4 hour delay,
press the OPTIONS pad once. A light will come
on indicating the delay start hours and will
remain on until cycle starts. Press the START/
CANCEL pad to start the delay option. If the
delay option is interrupted, the START/CANCEL
pad will have to be pressed again to return to
delay option.
To cancel the DELAY START option and begin
the cycle before the delay period is over,
press and hold the START/CANCEL pad for 3
seconds.
To Cancel a Cycle
You can cancel a cycle anytime during the cycle.
Press and hold the START/CANCEL pad for 3
seconds. The light above the cycle and option
selected will go out, the START/CANCEL light
NOTE
If the dishwasher door is opened while the
unit is running, the START/CANCEL pad must
be pressed and the door shut immediately
to return the unit to the selected cycle and
option, this must happen within 10 minutes
for the unit to continue the cycle.

Select the NORMAL WASH and HI-TEMP WASH
pads along with a Rinse Aid agent for improved
drying performance.
Drying Tip
will remain illuminated, the dishwasher will start
a 90 second drain. At the end of the drain,
select the next desired cycle.