Manual

General Cleaning
Prior to cleaning the coil elements make sure they are cold and that control knobs are set
at OFF.
Never immerse the coil elements in water.
Never leave covers on the coil elements as they could be permanently
damaged if turned on by accident.
To Remove and Replace Surface Elements and Drip Bowls (some models)
Before cleaning the cooktop, be sure the controls are turned to OFF and the cooktop is COOL.
Be careful
not to bend terminal ends
when replacing elements
after cleaning.
To Remove
1. Lift up edge of surface element across from terminal end just enough to clear the edge of
the drip bowl.
2. Gently slide the surface element out of the terminal plug.
3. Lift the drip bowl up and out.
To Replace
1. Line up the opening of the drip bowl with the terminal plug.
2. Hold the surface element aslevel as possible and slide the terminal end th rough the opening
and into the terminal plug.
3. Be sure the surface element is level to reduce the hazard of pans sliding off the element.
To Raise the Top for Cleaning
1. Grasp the sides and lift from the front. Some models may have a lift-up rod to support the top in its raised position. Lift the top
only high enough to allow the support rod to fit into place, then gently lower the cooktop onto the raised rod.
2. Clean underneath using a clean cloth and hot, soapy water.
3. Gently lower the cooktop into the frame. Ifyour model has asupport rod, lower the support rod, then gently lower the cooktop
into the frame.
_When lowering the lift-up cooktop, grasp the sideswith fingertips only. Be careful not to pinch fingers. DO NOT
drop or bend the cooktop when raising or lowering. This could damage the surface.
11