Complete Owner's Guide
5
First Steps
Front Fixed Caster Installation
Locate and align xed caster (with brake lever
facing front of unit - see Figure 3) over the
same mounting holes from bracket in Figure 1
using 6 hex screws (3 for each caster). Secure
the screws snug using a ⅜” open end wrench.
Repeat this procedure for opposite corner. DO
NOT OVERTIGHTEN.
Rear Swivel Caster Installation
1. Remove and discard the screws shown in
Figure 4 from each bottom corner using a
5/16” socket wrench.
Brake lever
Fixed
caster
Front
of unit
Hex
Screws
(3)
Figure 3
Remove screw
before installing
caster. Repeat
for opposite
corner
Figure 4
2. Locate and align swivel caster over the
holes and install with 2 hex screws.
Secure the screws snug using a 3/8”
socket wrench. DO NOT OVERTIGHTEN.
3. On the opposite side of the swivel caster
plate, insert 2 carriage bolts through the
compressor support rail and swivel caster
plate. Use a lock nut on each bolt and
tighten securely using a 9/16” socket
wrench. See Figure 5.
Install caster
using (2) hex
screws
(2) Carriage
bolts with
lock nut
Swivel caster
Figure 5
4. Repeat the same procedure for the
opposite rear corner.
5. With the help of an assistant, carefully
upright the unit. Reassemble the rear
access guard with screws.
CAUTION
Unit will roll forward as it is tipped up.
Appliance Placement
Leave a 1” space on all sides and the back of
the cabinet for ease of installation, proper air
circulation and electrical connections. DO NOT
block the front grill on the lower front of your
appliance. Sufcient air circulation is essential
for the proper operation of your appliance.
Choose a place that is near a grounded electrical
outlet. For the most efcient operation, the
appliance should be located where surrounding
temperatures will not drop below 40ºF (5ºC)
or exceed 110ºF (43ºC). Additional compressor
heaters are not recommended.
Insulation
The insulated space of this cabinet is sealed
to maintain peak efciency. Holes drilled in
the cabinet may destroy that seal and damage
electrical wiring located in the insulated space.
DAMAGED ELECTRICAL WIRING OR
WET INSULATION CAUSED BY DRILLING
WILL VOID THE WARRANTY.