Complete Owner's Guide

The following tools are required to assemble and install the casters to the unit:

Tools Needed

First Steps

Uncrating and Set-up

1. Remove carton and all loose parts from

inside the unit.

2. Remove the rear access guard and place

it and the screws in a safe place for

reassembly later.

3. Using an assistant, carefully tip the unit onto

its back and rest on blocks to avoid damaging

the condensate drain hose and the plastic

raceway that covers the evaporator tubing on

the back of the cabinet.

4. Remove and discard the two front

brackets with leg leveler using a 5/16”

socket wrench. See Figure 1.

5. FOR GLASS DOOR MODELS ONLY -

Remove bottom door support bracket and

screw opposite the door hinge using a ⅜”

socket wrench. See Figure 2.

5/16”, 3/8” and 9/16”

Socket or Open End Wrench

Adjustable

Wrench or

Pliers

Phillips

Screwdriver

Front Bracket &

Leveling Legs

Figure 1

Door

support

bracket

Figure 2

Door Swing Reversal

(stainless steel door models)

A door reversal kit is included with reversible models. If it is misplaced, order a service kit from

Frigidaire Commercial Service Center at 1-866-738-1640.

• For right hand swing doors, order kit #5304488173.

• For left hand swing doors, order kit #5304487215.



NOTE

Only Solid Door refrigerators can be reversed. Glass Door refrigerators cannot be reversed.