Installation guide

4. CHECK FOR ANYTHING THAT COULD BLOCK
AIRFLOW - check area outside of window for things
such as shrubs, trees, or awnings. Inside, be sure
furniture, &apes, or blinds will not stop proper air flow.
5. Check the available electrical service - power suppF must
be the same as that shown on the unit serial nameplate.
(See Owner's Guide for serial plate location.)Power cord
is 48"long. Be sure you have an outlet near.
Too|s Required
%/ a large flat blade screwdriver
%/ tape measure
%/ adjustable wrench or pliers
%/ pencil
%/ Level
%/ Socket wrenches
%/ Phillips screwdriver
All models have a 3-prong service plug to provide proper
service and sate positive grouding. Do not change plug m
any way. Do not use an adapter plug. If your present wall
outlet does not match your plug, call a qualified electrician
to make the needed change.
Aw_idfhehazaacdor electric
shock.Do notu_ anextenskmcordor an
adaptorplug.IX_notrelnoveanypro_ from
the power cord.
Grounding type wall
receptacle
not, under anii"_
drcumustances, cut,
remove, or bypass the
, grounding prong.
plug and current
detection device
6. Carefully unpack air conditioner - remove all packing
material. Protect floor or carpet from damage. Two
people should be used to move and install unit.
Hardware (in plastic bag)
_ Washer Head
Locking Screw
For window panels
3 "
/4 Long Hex-
Head Screw
Safety Lock
@_ 1/2"LongScrew
and locknut
__ /4" Long Flat
Head Bolt and
Locknut
Sill Angle Bracket
Long hex-head
locking screw for
top angle, side
retainer 5/16"
Long
Qty.
2
4 ea.
2 ea.
10