Installation guide

Wall Sleeve Brands:
#8 Wh_ Westing_se_Fti _/
_rder 52F _des
16 '_+ 17 %_
1, Remove exJ g rear grille as shown O_ e 2 of this
manual arid rep_ce wi:[h prov_ Iouvered rear panel.
Install as sh here.
2, A (!) 1" × 3/8 _x 25 _ I_g I _n_e center a_ the top
of the sle , Re _h,e ng p _and' p into
3, (2) !" x 3,_8_× !4" seals _ the left and right sides
of the sle_e,
4, (_) 1" x _"× i4" long ve Ily 3,5_°from _hele_
side of _e sle_¢e, _e o_er ! _'× %°x !4" long _al 3"
_om th_ rigN side o_the sl
5, r u_i:[ & g_tly slide unit into sleeve,
6, Before sliding all back, 2_d w #on4
on left s_,e of un_,
7, Remove the plas_c washer #ore the
8, Screw and a _e e_her end of the g_ound wre _ the
unA _s shown _n ure, M s_re _at th_ _eethc_ w_
is against the cabi_e_.
9, Slide the a_i:t completely to _e _ea_to e_sure _ g_ I
making s_r,e_e ground w_re _ ne_ become _n#led,
_0. Seal & Frame _e unit as de_ on the last _age of
these i_structions,