Installation guide

WaJJ SJeeve Brands: #5 Sears or Carrier 51S Series

185/8. Deep

TopView

1. Redirect the louvers at the back of the wall sleeve as shown

opposite. The use of pliers is recommended.

2. Install (2) tapered spacer blocks to the floor of the sleeve as

shown. DO NOT CUT THESE BLOCKS. This helps induce

a rearward slope on the unit.

3. Install as shown with the tapered end ½" from the back of the

sleeve, This helps induce a rearward slope on the unit.

4. Attach (1) 1 ½" x 3/8" x 25" long seal in the center at the top

of the sleeve. Remove the backing paper and press into

position.

5. Attach (2) 1 ½" x 3/8" x 14" seals to the left and rightsides

of the sleeve.

6.Cut (2) 1½" x3/8" x25" long seals to 14" long each

and attach to the vertical sections ofthe grilleas shown.

7. Center unit & gently slide unitinto sleeve.

8. Before sliding all-the=way back, remove 2nd screw from fi'ont

on leftside of unit.

9. Remove the plastic washer _'om the screw,

!0. Screw and attach the other end of the ground wire to the

unitas shown in picture, Make sure that the toothed washer

isagainst the cabinet.

11, Slide the unit completely to the rear to ensure a good seal,

making sure the ground wire does not become tangled,

12. Seal & Frame the unitas described on the last page of

these instructions.