Manual

Air Conditioner FeatureS(cont n.ed)

SLEEP FEATURE:

DO THIS:

PRESS

SLEEP PAD

HGHT ON

YOU W_LL SEE:

The Sleep Mode can be selected with a Heating or Cooling Mode. Note: In this "MODE" the selected cooling temperature

will increase by 2 degrees F, 30 minutes after the mode is selected. The temperature will then increase by another 2

degrees F, after an additional 30 minutes. This new temperature wil! be maintained for 7 hours before it returns to the

originally selected temperature. If this Mode is selected with Heat, the set temperature will Decrease at the same time

pattern. This ends the "Sleep" MODE and the unit wil! continue to operate as originally programmed. The "Sleep" MODE

program can be cancelled at any time during operation by pressing "Sleep" MODE button.

CHECK F_LTER FEATURE:

LIGHT ON

YOU W_LL SEE:

DOTHmS:

PRESS TO RESET

Note: This feature is a reminder to clean theAir Filter (See Care and Cleaning) for more efficient operation and cooling. The

LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Clean Filter" button and

the light will go off.

REMOTE SENSING FEATURE (on some mode_s)

YOU W_LL SEE:

LIGHT Pulsing On

& Off Intermittently

DO TH_S:

PRESS SENSING

START BUTTON

Note: unit display show

"set" temperature

Note: remote display is

actua! temperature at

remote control only

Note: This feature can be activated from the remote control ONLY.

To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing start button.

The LIGHT on the unit contro! will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each

time it sends a signal. It will continue to send this signal unti! the feature is deactivated by pressing the remote sensing stop

button. If the unit does not receive the remote sensing signal during any 3 minute interval, the unit will keep to indicate the

remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY. The unit

display indicates the set temperature.