Installation guide

ManualsBrandsFrigidaire ManualsRoom air conditionerOfficial Frigidaire air conditioner

Installation Instructions

READ BEFORE INSTALLING UNIT

Compact II Window Mounting

Y_ur air conditioner is designed to install ill standard

double hung windows with opening widths of 23 to 36

inches (584 mm to 914 mm) (FIG. 1)

Lower sash must opeu sufficiently to allow a clear vertical

opening of 14-1/2 inches (368 mm). Side louvers and the

rear of the AC must ha_e clear air space to allow

enough airflow through the condenser; for heat removal.

The rear of the unit must be outdoors, not inside a

building or garage.

When handling unit, be careful to avoid cuts

from sharp metal edges and aluminum fins on

fl'ont and rear coils.

Before installing the unit, the Left-Hand

Louver nmst be assembled to the unit:

Fig. 1

Careflflly remove power supply

cord from air discharge area

(Fig. A/.

Careflflly remove the Left-Hand

Louver Assembly from the

discharge area. and then remove

it from the plastic bag(Fig. B/.

NOTE: SAVE CARTON and these INSTALLATION

INSTRUCTIONS for flmlre reference. The carton is the

best way to store unit during winter, or when not in use.

With care, pry apart the auger

wheel shaft from the horizontal

louver casing, as shown in Fig.

C,D& E.

Some assembly is required. Please read these instructions

carefally.

Mounting Hardware

Qty.

3/4"screws

lock frame

sash lock

TOOLS NEEDED:

• Phillips Screw Driver

• Drill (If pilot holes are needed/

.......................... j/

Now locate the auger wheel

shaft into the vertical center

post (Fig. F).

Clip the other end into the

locating slot.

Now place the horizontal louver

casing onto the auger wheel

shaft, and snap in place (Fig.

G).

Check the operation by moving

the horizontal louver up and

dowm and then turn the auger wheel so the vertical

louvers rotate.

P/N 66129901166

Summary of content (3 pages)

PAGE 1
Installation Instructions READ BEFORE INSTALLING UNIT Compact II Window Mounting Y_ur air conditioner is designed to install ill standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 1) Lower sash must opeu sufficiently to allow a clear vertical opening of 14-1/2 inches (368 mm). Side louvers and the rear of the AC must ha_e clear air space to allow enough airflow through the condenser; for heat removal.
PAGE 2
How to Install NOTE: Top Rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to tile rear must be maintained! Place unit on flooL\ a bench or a table. There is a Left and Right Window Filler Panel - be sure to use the proper panel for each side.
PAGE 3
Place the frame extensions lock between and the window (Fig. 8). Drive 3/4" through the frame (FIG. 9). NOTF: To prevent splitting, drill 1/8" (3 ram) driving screws. screws the frame Cut foam seal and insert in the space between the upper and lower sashes (FIG. 13). sill as shown (19 ram) locking lock and into the sill window sill from pilot holes before IfAC is Blocked by Storm Window Add wood as shown in FIG. 14, or remove window before air conditioner is installed.