Manual

Air Conditioner Features
(continued)
REMOTE SENSING FEATURE
(on some models):
YOU WILL SEE:
LIGHT pulsing On & Off intermittently.
FAULT CODES:
Note: This feature can be activated from the remote control
ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control
towards the unit and press the remote sensing button. Next,
use the A _F' buttons to set the desired temperature at the
remote. (Note that the set temperature wiII only be displayed
on the unit itself). The LIGHT on the unit control witI pulse to
indicate it received the signaI. The LIGHT on the remote control
wilt pulse each time it sends a signal. It wilt continue to send
this signal until the feature is deactivated by pressing the remote
sensing button. If the unit does not receive the remote sensing
signal during any 3 minute interval, the unit wilI beep to indicate
the remote sensing mode has ended. The display on the remote
control indicates the temperature at the remote ONLY.
Remote Sensing: The Remote Sensing function is terminated
using the remote control Start/Stop button or the Remote Sensing
Stop button, and also the main Start/Stop button on the unit.
tf the display reads "ES" or "AS", a sensor has failed.
Contact your Authorized Frigidaire Service Center.
TO TURN UNIT OFF:
DO THIS:
PRESS ON/
JOFF BUTTON