Installation Guide
INSTALLING YOUR BEVERAGE CENTER
Electrical Requirement
•
Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with
proper grounding to power the Beverage Center.
•
Avoid the use of three prong adapters or cutting o the third grounding
prong in order to accommodate a two prong outlet. This is a dangerous
practice since it provides no eective grounding for the Beverage Center
and may result in shock hazard.
•
Do not install your Beverage Center in any location not properly insulated
or heated (e.g., garage etc.). Your Beverage Center was not designed to
operate in ambient temperature settings below 55°F Fahrenheit.
•
Select a suitable location for the Beverage Center on a hard even surface
away from direct sunlight or heat source (e.g., radiators, baseboard heaters,
cooking appliances, etc.). Any floor unevenness should be corrected with
the leveling legs located on the front and rear bottom corners of the
Beverage Center.
•
Your Beverage Center is designed for freestanding installation only. It is not
designed for built-in application.
Note: This unit is for indoor use only.
•
Avoid the use of an extension cord because of potential safety hazards
under certain conditions. If it is necessary to use an extension cord, use only
a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot
outlet that will accept the plug. The marked rating of the extension cord
must be equal to or greater than the electrical rating of the appliance.
Installation Limitations
Use of Extension Cord
WARNING: ELECTRICAL REQUIREMENT - SHOCK HAZARD
6