Artic Air Commerical Glass Door Refrigerator Owner's Guide

6
Swivel Casters
The appliance comes with 2 swivel casters and 2
nonswivel casters (with brakes). The casters allow the
appliance to be moved with ease, and then locked into
place upon final destination. (Refer to page 4 for
instructions.)
Adjustable Temperature Control
The adjustable thermostat control is located on the top
left panel inside the unit.
Interior Thermometer
The appliance comes with a thermometer to show
internal temperatures. The thermometer is to be hung
from the top adjustable shelf on the right hand side.
Interior Light
• The appliance is equipped with a 17 watt
fluorescent lamp. A ballast - lamp mismatch may
result in poor or no performance.
• If lamp goes bad, replace with lamp of same type
and wattage. Also, replace a lamp that flickers
continuously. This could damage the ballast.
• Turning lights off, when not in use, will save energy.
However, frequent ON-OFF cycling will reduce the
lamp life.
• Use an NSF certified lamp (216659500), which can
be ordered from your Arctic Air Service Center by
calling 1-800-490-9574.
Routine Maintenance
Cleaning the Interior
Be sure to turn the temperature control to off and
unplug the electrical cord. Wash the inside surface of
the storage area with warm water and baking soda
solution (about one tablespoon of baking soda per
quart of water). Rinse thoroughly with clean, warm
water and wipe dry. The procedure can also be used
for cleaning the door gasket. Wipe the stainless steel
cover plates with Magic Clean Stainless Steel Cleaner
(can be ordered from your Arctic Air Service Center
P/N 218490900) or some other stainless steel cleaner.
Cleaning the Exterior
Wipe the textured cabinet exterior occasionally with a
cloth dampened in mild detergent and water, rinse
and wipe dry with a soft cloth. Wipe the stainless
steel door plate and toe grill with Magic Clean
Stainless Steel Cleaner or some other stainless steel
cleaner. Do not use razor blades or other sharp
instruments that can scratch the appliance surface
when removing adhesive labels. Any glue left from the
tape can be removed with a mixture of warm water
and mild detergent or touch the residue with the sticky
side of tape already removed. DO NOT REMOVE THE
SERIAL PLATE.
Condensate Pan
The condensate pan is in a fixed position and must not
be removed from under the cabinet. If the pan is
removed, condensate will drip onto the floor.