Use and Care Manual Dishwasher 740 and 750 Series

6
Very Important
Information— Read Before
Operating Your Dishwasher!
Normal Operating
Sounds
This dishwasher does not sound like most
dishwashers—IT’S QUIETER!
Your dishwasher uses energy efficient motors
for the wash and drain portions of the cycle
you select. Each cycle has a series of water
fills and drains for washing and rinsing
dishes. As each cycle begins, you may–or
may not–hear the drain motor.
The next sound you will hear is the splashing
water as it enters the tub. Then the lower arm
rotates and circulates water. This is followed
by a pause and a slightly different sound as
the upper arm sprays water. If you listen
closely, you will hear the change in sound as
the wash action switches from one arm to the
other.
PLEASE BE ADVISED: If you compare
this dishwasher to previous models, you
may be surprised at what you DON’T hear!
750 Series
Operating Instructions
Vent Latch
Delay Start
Allows you to delay starting the POTS & PANS
cycle up to 6 hours.
• Turn dial to select number of hours.
• Select HI-TEMP WASH ON option and
other desired options.
• Close door to latch. The DELAY START
light will come on.
Getting Started
1. Load dishwasher (See Preparing and
Loading Dishes).
2. Add detergent (See Dishwasher Dispenser
& Detergents).
3. Add rinse aid, if needed (See Rinse Aid).
4. Turn dial clockwise to select cycle (See
Cycle Chart) or number of hours for delay
start.
5. Select desired energy OPTIONS (See
Energy Options). The indicator will show
red when selected.
6. If using DELAY START, go to step number
8.
7. Run hot water faucet nearest dishwasher
until water is hot. Turn water off.
8. To start, close door to latch.
Status Indicator Lights
When DELAY START option is selected, the
Delay Start light will glow as timer counts
down to begin cycle.
The HEATING DELAY light means the cycle is
being extended to heat water to proper
temperature in the main wash or final rinse,
based on options selected.
CLEAN light comes on when a cycle is
complete. To turn it off, turn dial slightly until
light goes off.