Manual

Appendix B: Installation of

Central Desk Control

Follow steps 1 through 5 (pages 4 and 5), then:

6. Attach two wires from the central desk control to the

terminal board on the right side of the control box.The

central desk control must provide 24 volts AC to this

terminal board in order to switch the unit to the unoc-

cupied mode. When the 24 volts AC is turned off, the

unit returns to the occupied mode.

If filter is not in place, locate and place as shown.

Install the front panel by placing the top of the panel

onto the brackets at top of the chassis. Rotate the

bottom into place while locating the service cord

(or conduit) in the notch at the bottom or sides of

the front panel.

Secure the panel to the chassis with two #10 x

3/4" screws (provided). Attach the bottom return

air louver to the front panel. The louver can be se-

cured in place with two #10 x 3/4" screws provided

(optional).

Place on

brackets

here.

(_ Filter

f. ....

Front Panel

(not in place yet)

_ Evaporator Coil

In//

....,1_- _ Thermostat Bulb

NOTE: Two screws are in

each side of front panel.

Louver Screw _ I

Front Panel

Screw