User's Manual

Routine Maintenance

Cleaning the unit:

The outer cover of the Breeze indoor module can be cleaned with a damp

cloth.

Cleaning the outdoor module can be done by rinsing the module with low

pressure water. Refer to friedrich.com for approved coil cleaning agents.

Cleaning the lter:

The indoor module of the Breeze system has a washable lter that

should be inspected and cleaned periodically. To access and clean the

lter follow these steps.

1. Open the front panel by pulling on the left and right side tabs. The

front panel will open upward and lock into the open position.

2. Remove the left and right air lters from the Breeze module.

3. Wash the lters by rinsing with water or by vacuuming the dirt from

the lter. Allow the lter to dry completely prior to reinstalling.

4. Reinsert both air lters. Then, lower the front panel and snap the

panel into place.

STEP 9 – Locate the condensate drain.

The connecting line has a built in condensate line hose that removes the moisture collected from the indoor module.

The hose must be located in an appropriate location for drainage. Because the hose relies on gravity to drain, it is

important that the hose only points downward for the entire length of the hose.

If the connecting line is rolled to store the excess line as shown in Step 6, the drain line may be removed from the

connecting line as shown below and cut to an appropriate length.

STEP 10 – Final Preparation.

Using the supplied connecting line clips (Item #14 in the

Accessories List), secure the connecting line to the interior and

exterior walls as desired. 5 retaining clips are provided from the

factory along with standard #8 x 1 1/2” screws and wall anchors.

For installations with the connecting line going through the wall

(option 1) use the supplied ller gasket (Item #7 in the Accessories

List) to plug the hole around the connecting line in the wall

opening. Additional sealing may be desired or necessary for

proper weatherproong.

Once the connecting line is secure and Steps 1-9 are complete, you

may plug in the Breeze system and enjoy your new air conditioner.

STEP 9

Peel away

SCORE AND PEEL