Installation & Operation Manual (2019, 2020)

ManualsBrandsFriedrich ManualsAir ConditionersChill Premier Smart Room Heat + Cool Air Conditioner — 24,000 BTU, 230 Volts

1. Power: Turn the air conditioner on and off. This button will

clear the TIMER setting.

2. MODE: Press the button to select the mode of operation, AUTO, COOL,

DRY, FAN ONLY, HEAT.

Note: The HEAT mode is only for some heating models. If you do not

need it, press the MODE button for more than 5 seconds to delete the

HEAT function, and the COOL mode will be selected automatically.

Press the MODE again for more than 5 seconds to add the HEAT

function, and the HEAT mode will be selected automatically.

3. And : Use these buttons to increase or decrease the setting

Temperature or Timer. Setting temperature range: 61 ~88 or 16 ~31 .

Note: When the remote controller is turn-off, press and buttons can

pre-set the temperature. After the setting, the remote temperature display

will be off after a while.

4. TURBO: When the remote is ON, press the button to active the TURBO

function, under AUTO/COOL/FAN ONLY mode. Press again to cancel the

TURBO function, and the fan speed will change to pre-setting before.

Note: and change: After insert the batteries, in the off state within 3

minutes, press the TURBO button for more than 5 seconds to switch the

Fahrenheit ( ) or Celsius ( ) degree display.

5. DISPLAY: When the unit is ON, press the button, to switch off/on all lights

or LED display. And this function will be canceled when changing mode.

6. TIMER: Use the button to set the TIMER, or cancel the TIMER.

TIMER OFF: When the unit is ON, the timed OFF is programmed by

pressing TIMER button, the remote will display 6 hours pre-setting at first.

Set the rest time by pressing the button or until the needed rest time

display, then press TIMER button again to confirm.

TIMER ON: When the unit is OFF, the timed ON is programmed by pressing

TIMER button, the remote will display 6 hours pre-setting at first. Set the

rest time by pressing the button or until the needed rest time display,

then press TIMER button again to confirm. Later, the remote screen will keep

display [TIMER] icon.

Note: When TIMER ON, it cannot select Sleep mode, but can pre-set Mode,

temperature, fan speed, ECO.

7. SLEEP: Press the SLEEP button, all of the display lights will turn off after a

while, but the Sleep light is always on. In SLEEP mode, the air conditioner

will automatically adjust the temperature and fan speed to make the room

more comfortable during the night. The set temperature will automatically

raise every 30-60 minutes and at most change six times until the set

temperature is 81 or 82 . This function can be selected when COOL or

HEAT mode.

8. FAN SPEED: Press the FAN SPEED button to choose the fan speed options.

You can choose Hi, Med, Lo or Auto speed in COOL or HEAT mode and

choose Hi, Med, Lo in FAN mode. When DRY mode, it is only Low fan speed.

9. MONEY SAVER: When the unit is in COOL mode, press the button to

MONEY SAVER function. In MONEY SAVER mode, the unit will turn off

once the room is cooled to the user set temperature. The unit will turn back

on when the room temperature rises above the user set temperature. Before

the compressor starts, the fan motor will run for 20 sec., then it will stop for

10 min., and will repeat to provide a much more comfortable feeling and

save energy.

10. Child Lock: pressing the button or for more than 2 seconds to lock

or unlock the remote controller. When locked, each function button is no

useful, and the lock icon will flash when press any button.