FREEDOM-WEB Ready-to-Assemble Privacy Vinyl Fence INSTALLATION INSTRUCTIONS Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. To register your product, please visit: freedomproduct.
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Check local building codes to determine pool-safe fencing options. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store. For assistance or replacement parts call: 1-800-336-2383.
1 Mark the fence location using string and line stakes (Fig. 1). Fig. 1 NOTE: Plan gate placement, opening and hardware clearance before installing fencing. 2 Post Location: Fig. 2 Measure the width of the fence panel (X) plus the width of the post (Y). This is the common center-to-center measurement (unless there is a cut-down panel) for post hole location (Fig. 2). X Y Post Installation: Dig the first two post holes.
5 When included in kit, place aluminum insert into bottom rail, then insert bottom rail into bottom post route hole of first post only (Fig. 5). Panels with 7" rails do not require aluminum inserts. Attach U-channels to two end boards (Fig. 6). NOTE: Attach U-Channel to "tongue" side of first board, and "goove" side of last board. Fig. 5 U-Channel Fig. 6 First Board Last Board U-Channel 6 Insert boards into bottom rail ensuring U-channels are on both ends.
8 For Lattice Top Panels: Fig. 9 Top Rail Add the lattice insert over the top of the lattice (Fig. 9). Lattice Insert Place lattice into the middle rail followed by the top rail. Middle Rail 9 Lattice Finally, add the completed top assembly into the route holes of the first post (Fig. 10). Fig. 10 Proceed to Step 15. 10 For Closed Top Panels: Fig. 11 Pickets Insert pickets into middle rail (Fig 11). Middle Rail 11 Guide top rail over picket tops (Fig. 12). Fig.
13 For Open Top Panels with Pickets: 14 Insert pickets down through top and middle rail (Fig. 15). 15 Insert the completed fence panel into the route holes of the second fence post. Plumb and level the post and add concrete according to manufacturers instructions to top of hole (Fig. 16). 16 6 Fig. 14 Attach middle rail into left side of post route only then guide rail over boards. Insert top rail into left post route holes of first post only (Fig. 14). Fig.
