User Manual

-55-
Model UR-2 <Playback>
While the unit is stopped, pressing the [PLAY]
key while holding down the [STOP] key enters
the scrub mode, and the display changes to show
the screen as below.
Digital scrub function
MAX
MIN
M
MIN
MIC GAI
N
INPUT LEVELABS 0
REC END
REC RDY EXIT
CUE/LOCATE
MIC IN
MIC SET
Y
FILE/CURSOR
MENU / ENTER
REC
STOP
PLAY
REW
F FWD
MRGN RST
CUEPREV NEXT
TIME EDIT
UR-2
STEREO RACK MEMORY RECORDER
[PLAY] key
[STOP] key
The " " on the screen above indicates the cur-
rent position. While this screen is shown, you can
scrub forward or backward in approximately five
to ten millisecond steps using the [MENU] dial.
After performing digital scrub, pressing the [EN-
TER] key exits the scrub mode.
[MENU] dial/[ENTER] key
<Digital scrub screen>
By setting the "Power On Play" menu item in the
PLAY SETUP menu of the MENU mode to "On"
before turning off the power, the unit automati-
cally start playback of files in the current stor-
age device next time you turn on the power.
<Memo>: After turning on the power when the
"Power On Play" menu item is set to "On", the
unit starts playback in the playback mode you
set before turning off the power. (Note that the
power on play function is not active in the
"MEMORY play mode" or "TIMER play mode".)
<Memo>: By default, the "Power On Play" menu
item is set to "Off". See "PLAY SETUP menu de-
tails" on page 58 for details about the "Power
On Play" menu item.
Power on play function
<Note>: To use a timer for power-on play, follow
the procedure below.
1) Turn off the unit.
2) Connect a timer to the unit.
3) Set the timer appropriately.
4) Press the [POWER] switch to "On" (up)
position.
<Note>: When more then one folder exists on the
current storage, the power on play function does
not work. The unit brings up the folder selec-
tion screen and stops after it is turned on (see
page 29).