User Manual

-44-
Model UR-2 <Playback>
Playback in CHAIN ALL play mode
In the CHAIN ALL play mode, the unit continu-
ously plays back all files in the chain play list
from the first file. After finishing playback of the
last file in the chain play list, the unit stops at
the beginning of the first file.
To start playback from a desired file, select the
file using the [
] or [ ] key, or using the file
selection screen (see page 42).
<Note>: When the unit switches the playback file,
if the next file has different FS/bit, it takes some
time to switch the file. Therefore, there is a si-
lent space between files.
Playback in CHAIN SINGLE play mode
In the CHAIN SINGLE play mode, the unit plays
back a selected file in the chain play list. After
finishing playback, the unit stops at the begin-
ning of the next file.
To play back a different file, select a desired file
using the [
] or [ ] key, or using the file se-
lection screen (see page 42).
<Memo>: By activating the repeat function, you
can play back a file repeatedly until you stop by
pressing the [STOP] key (see page 54).
<Memo>: By activating the repeat function, you
can play back a file repeatedly until you stop by
pressing the [STOP] key (see page 54).
<Memo>: You can mix a microphone source while
playing back a file.
You can also output the microphone signal alone
while the unit is stopped. (See page 38.)
<Memo>: You can mix a microphone source while
playing back a file.
You can also output the microphone signal alone
while the unit is stopped. (See page 38.)
When you select the CHAIN SINGLE play mode,
"
" lights on the display, while the
unit reads the chain play list information and
stops at the beginning of the first file in the list.
When you select the CHAIN ALL play mode,
" " lights on the display, while the unit
reads the chain play list information and stops
at the beginning of the first file in the list.
<Note>: When no chain play list is created,
"CHAIN LIST Empty!" is briefly shown followed
by the following screen. In this case, create the
chain play list and select the CHAIN SINGLE play
mode again. See page 46 for details about how
to create the chain play list.
<Note>: When no chain play list is created,
"CHAIN LIST Empty!" is briefly shown followed
by the following screen. In this case, create the
chain play list and select the CHAIN ALL play
mode again. See page 46 for details about how
to create the chain play list.