User Manual

-23-
Model UR-2 <Preparation>
By pressing the [POWER] switch, you can power
on the unit.
If the unit starts up without any storage devices
inserted, the display shows the following Home
screen.
The UR-2 has the internal clock, which is adjusted
according to the local time when shipped. There-
fore, set the time to your local time before using
the unit.
The internal clock time is used for the default
file name of a file which is created when record-
ing, the file creation date/time, the time stamp
of a BWF file, and the start time of the timer play
function. Therefore, it is recommended to set the
internal clock correctly.
1) Press the [ENTER] key to enter the MENU mode.
2) While "SYSTEM SETUP" is highlighted, press
the [ENTER] key.
The display now shows the menu items of
the SYSTEM SETUP menu.
3) Use the [MENU] dial to highlight "Adjust RTC."
and press the [ENTER] key.
The display now shows the current date/
time of the internal clock.
<Note>: To add the time data to a file name, set
the "Default File name" item in the SYSTEM
SETUP menu of the MENU mode appropriately
(see page 73).
For details about the display shown when start-
ing up the unit with a storage device inserted,
see "Setting a storage device" on page 26.
Turning off the power
Flashing
Turning on the power
Setting the internal clock
To turn off the power, simply press the [POWER]
switch.
However, during playback or recording, the
[POWER] switch is disabled and you cannot turn
off the power by pressing the [POWER] switch.