Installation Guide

24
AL
13
HOME TRADITIONAL PANEL INSTALLATION
ANGLE BRACKET: POST MOUNTING
• Reference OTP & Proud Post mounting instructions on page 5.
Note:
IT’S RECOMMENDED TO INSTALL BRACKETS ON TO POST BEFORE
POST MOUNTING.
A
C
A
B
Fig. 1
Bracket Hole Locations
4-3/16” [106.5mm]
A*
35-3/8” [899mm]
B
41-5/16” [1049mm]
1” [25.5mm]
C
*Dimension A positions bottom edge of rail 3-1/2” above deck surface.
*Dimension A is measured from the bottom surface of post base.
Fig. 2
Pre-Drill Dimensions: Pre-Drilling with a 3/16” [ 4.5mm] drill bit is required.
2-9/16” [65mm] 1” [25.5mm]
ANGLE BRACKET: BRACKET INSTALLATION
Step 1: Mark Bracket Hole Locations
1. Mark the centerline of each post with a pencil.
2. Take measurements used in Fig. 1 and 2 to mark bottom and
top bracket hole locations onto posts.
Note:
• Installed panel heights include space between the deck surface
and underside of bottom rail. AL
13
HOME 32.5” [825.5mm]
panels have a 3-1/2” [89mm] space. AL
13
HOME 40”
[1,016mm] panels have a 2” [51mm] space.