Installation Guide

Fe
26
AXIS INSTALLATION
17
Fig. 35
MDC
Stamp
Step 2: Install I-Support On Boom Rail (Oponal)
 1. Measureandlocatethecenteroftheboomrail.Using
  theI-Supportasaguide,markthecenterofthe2screw 
 holes.AsshowninFig.37.
 2. Usinga3/16”[5mm]drillbit,drillthoughtheoutsidewall.
 3. InstalltheI-SupportwiththeprovidedT-25threadcung 
 screws.AsshowninFig.38.
Fig. 36
Spot
weldson
under side
of rails
Fig. 37
3/16”
[5mm]
Hole
Fig. 38
Phillips
Head
Screws
Step 3: Install Panel
 1. Installcutpaneltoensurepropert.AsshowninFig.39.
Fig. 39