User Guide

and the perimeter alarm (if equipped) will start the arming process. For

more information concerning the perimeter alarm, refer to Perimeter

alarm system (if equipped) later in this chapter.

2. Press

and release again within three seconds to confirm that all the

doors and liftgate are closed and locked. Note: The doors will lock again

and the horn will chirp once.

If any of the doors or the hood are not properly closed, the horn will

chirp twice and park/turn lamps will not flash when the

control is

pressed.

Sounding a panic alarm

Press

to activate the alarm. To deactivate the feature, press the

control again, turn the ignition to the 3 (RUN) or 4 (START) position, or

wait for the alarm to time out in approximately 3 minutes.

Note: The panic alarm will only operate when the ignition is in the 1

(LOCK) or 2 (ACCESSORY) position.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin between the two

halves of the remote entry

transmitter near the key ring. DO

NOT TAKE THE RUBBER COVER

AND CIRCUIT BOARD OFF THE

FRONT HOUSING OF THE

REMOTE ENTRY TRANSMITTER.

2005 Escape (204)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security