Maintenance and Service Guide

105,000 miles
❑
Change engine oil and replace oil filter
❑
Change manual transmission fluid (except Escape)
❑
Replace cabin air filter (if equipped)
❑
Change rear axle fluid only on vehicles equipped
with DANA axles (see Special Operating
Conditions on page 41 and Exceptions on page
47)
❑
Change engine coolant (see Engine Coolant
Change Interval on page 6 and Coolant
Change Record on page 48)
❑
Inspect steering linkage, ball joints, suspension,
tie rod ends, driveshaft, and U-joints (lubricate if
equipped with Zerk fittings)
❑
Torque the rear U-bolts (Transit Connect only)
❑
Inspect engine cooling system and hoses
❑
Inspect brake pads, shoes, rotors, drums, brake
lines and hoses and parking brake system.
❑
Inspect half shaft boots (if equipped)
❑
Inspect exhaust system and heat shields
❑
Inspect automatic transmission fluid level (if
equipped with an underhood dipstick)
❑
Inspect and lubricate 4x4 front axle U-joints
❑
Rotate tires, inspect tires for wear and measure
tread depth
❑
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
❑
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
112,500 miles
❑
Change engine oil and replace oil filter
❑
Inspect cabin air filter (if equipped)
❑
Rotate tires, inspect tires for wear and measure
tread depth
❑
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
❑
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
N ORMAL S CHEDULE T RUCKS ,F ULLSIZE V ANS & SUV S
Scheduled Maintenance 23
2010 Scheduled Maintenance Guide (smg)
Scheduled Maintenance Guide, 2nd Printing
USA (fus)
Normal Schedule
Trucks, Fullsize
Vans & SUVs