Owner's Manual

Note: If the battery is disconnected, discharged, or a new battery is

installed, the dimmer control requires re-calibration. Press the dimmer

control from the full dim position to the full on position to reset. This

will ensure that your displays are visible under all lighting conditions.

AIMING THE HEADLAMPS

The headlamps on your vehicle are properly aimed at the assembly plant.

If your vehicle has been in an accident, the alignment of your headlamps

should be checked by your authorized dealer.

Vertical aim adjustment

1. Park the vehicle directly in front of a wall or screen on a level surface,

approximately 25 feet (7.6 meters) away.

• (1) 8 feet (2.4 meters)

• (2) Center height of lamp to

ground

• (3) 25 feet (7.6 meters)

• (4) Horizontal reference line

2. Measure the height of the

headlamp bulb center from the

ground and mark an 8 foot

(2.4 meter) horizontal reference line

on the vertical wall or screen at this

height (a piece of masking tape works well).

3. Turn on the low beam headlamps to illuminate the wall or screen and

open the hood.

To see a clearer light pattern for adjusting, you may want to block the

light from one headlamp while adjusting the other.

4. On the wall or screen you will

observe an area of high intensity

light. The top of the high intensity

area should touch the horizontal

reference line, if not, the beam will

need to be adjusted using the next

step.

Lights

2010 Fusion (fsn)

Owners Guide, 2nd Printing

USA (fus)