Owner's Manual

2. Press and release the RESET button. HOLD RESET TO CONFIRM

MYKEY will be displayed.

3. Press and hold the RESET button for two seconds until MARK THIS

AS RESTRICTED is displayed.

4. Wait until KEY RESTRICTED AT NEXT START is displayed.

MyKey™ is successfully programmed. Make sure you label it so you can

distinguish it from the admin keys. Note: To program the optional

settings go to Step 2 in the Programming MyKey™ pptional settings

section. If your vehicle is equipped with remote start, see the Using

MyKey™ with Remote Start Systems section.

Note: The MyKey™ can be cleared within the same key cycle that it was

created, otherwise a standard key (administrator key) is required to

disable the MyKey™ programming. To clear all MyKeys™ go to Step 2 in

the Disable MyKey™ section.

Programming MyKey™ optional settings

Turn the ignition on using an admin key. To program the optional

settings, use the message center buttons to do the following:

1. Press SETUP until RESET FOR MYKEY SETTINGS is displayed.

2. Press and release the RESET button to display MyKey™ setup menus.

The first menu shown is:

MYKEY MAX MPH <80 MPH> OFF

3. If you don’t want to change the maximum speed setting, press the

SETUP button to display the next menu. The remaining menus appear as

follows with the default settings shown:

MYKEY MPH TONES 45 55 65 <OFF>

MYKEY VOLUME LIMIT <ON> OFF

MYKEY ADVTRAC CTRL ON <OFF>.

4. On any of the menus press RESET to highlight your choice with the

<…>.

5. Press SETUP to enter your choice. The next optional setting will be

displayed.

6. Repeat Steps 4 and 5 until you are done changing the optional

settings.

Disable MyKey™

To reset all MyKeys™ as admin keys do the following:

1. Turn the vehicle on using the admin key.

Locks and Security

2010 Escape Hybrid (ehv)

Owners Guide, 2nd Printing

USA (fus)