Maintenance and Service Guide

30,000 miles
Change engine oil and replace oil filter
Inspect automatic transmission fluid level on
vehicles if equipped with dipstick. Consult
your dealer for particular requirements.
Replace cabin air filter (if equipped)
Replace climate-controlled seat filter (if equipped)
Replace engine air filter
Replace fuel filter (except Escape, Mariner,
F-Series [non Super Duty],
Expedition/Navigator [short wheel base only],
E-Series)
Inspect steering linkage, ball joints, suspension,
tie rod ends, driveshaft, and U-joints (lubricate if
equipped with Zerk fittings)
Inspect engine cooling system and hoses
Inspect brake pads, shoes, rotors, drums, brake
lines and hoses and parking brake system.
Inspect half shaft boots (if equipped)
Inspect exhaust system and heat shields
Inspect and lubricate 4x4 front axle U-joints
Rotate tires, inspect tires for wear and measure
tread depth (vehicles with dual rear wheels
should only rotate if unusual wear is noted)
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
37,500 miles
Change engine oil and replace oil filter
Rotate tires, inspect tires for wear and measure
tread depth (vehicles with dual rear wheels
should only rotate if unusual wear is noted)
Inspect the wheels and related components for
abnormal noise, wear, looseness, or drag
Perform multi-point inspection (recommended)
DEALER VALIDATION:
RO#: P&A C
ODE:
D
ATE:MILEAGE:
N
ORMAL
S
CHEDULE
T
RUCKS
,F
ULLSIZE
V
ANS
& SUV
S
Scheduled Maintenance
17
2009 Scheduled Maintenance Guide (smg)
Scheduled Maintenance Guide, 2nd Printing
USA (fus)
Normal Schedule
Trucks, Fullsize
Vans & SUVs