Use and Care Manual

Flush Floor Vent
[Lite]
Install Guide
1
Drop in base on subfloor and
fasten with wood screws.
*DO NOT use provided screws here.
Dry fit Body into Base.
2
Install surface material on top of
Base so that it is completely flush.
3 4
With the resistance from the flange,
adjust Body up and down until it is
flush with the top of surface.
5
Once adjusted to prefered height,
fasten the Body to the Base using
provided screws through the four
pilot holes in each corner
*Control Air Flow*
Slide to remove tray and adjust flange open and closed. For optimal air flow, push flanges past 90º.
Additional Support
support@fies.com / www.fies.com
Made in Canada
6
7
8
Backfill Tray with bonding material
and place precut piece of surface
material inside Tray.
Hold in place and flip Tray. Apply even
pressure until surface material lies flat
with the rim of Tray. Leave to cure.
Insert and slide Tray in place.
Enjoy!