Lawn Mower User Manual

K3034pr-0920
1
2
7
BATTERY CHARGING
K3034pr-0920
E
Battery Retainer
• Plug the charger into a standard wall outlet.
Notes:
– If power flow to the wall outlet is controlled by a switch, make
sure the switch is ON.
– Use the charger only in a wall outlet. Do not plug the charger into
a ceiling outlet.
• Before first time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery after each use of your vehicle for at least
14 hours. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the charger connector
from the battery connector. Unplug the charger from the wall outlet.
The battery is now ready to be installed in your vehicle. Please
see “Battery Installation” on page 12 for detailed instructions
on installing your battery. If your battery is already installed in
your vehicle, simply re-connect the battery connector and motor
connector and replace the battery retainer.
IMPORTANT! The battery must be removed from your vehicle for the
initial charge in order to complete assembly. You do not need to
remove the battery from the vehicle to recharge it.
• Using a Phillips screwdriver, loosen the screw in the battery retainer.
Remove the battery retainer from the vehicle.
• Remove the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery from the
battery compartment.
• Discard any cardboard that may have been used to protect the
battery during shipping.
• Fit the charger connector and the battery connector together.
Battery
Connector
Charger
Connector