Grow-With-Me Trike Model Number: 72667 Instructions Please keep these instructions for future reference. Adult assembly is required. Tools needed for assembly: Hammer, Phillips Screwdriver, Scrap Block of Wood. If you have any questions about this product, or are missing a part, please call us toll-free at 1-800-432-KIDS, rather than return this product to the store. Age: 2 - 6 years. Weight Limit: 60 lbs.
Message to Parents WARNING • Adult supervision is required. • Never use near steps, sloped driveways, hills, ditches, roadways, alleys, swimming pool areas or other bodies of water. • Always wear shoes or sneakers. • Never allow more than one rider. • Observe child weight limit: maximum 60 lbs. Thank you for purchasing the Fisher-Price® Grow-With-Me Trike for your child. The Grow-With-Me Trike starts off as a regular tricycle for the youngest riders and then converts to a low rider as your child grows.
Parts • Please save all packaging material until assembly is complete to ensure that no parts are discarded. • If you are missing a part, please call us toll-free at 1-800-432-KIDS, rather than return this product to the store. • Please wipe each part with a clean, dry cloth before assembly.
Assembly 1 3 Frame Axle Hole Axle Hole Straight Axle Straight Axle Cap Nut • Turn the frame upside down. • Insert the straight axle through the axle holes in the rear of the frame. Cap Nut Assembly Tool 4 Indented Side Up • • • • Place a scrap block of wood on a flat surface. Fit a cap nut into the cap nut assembly tool. Place one end of the straight axle into the cap nut. Tap the end of the straight axle with a hammer. Make sure the cap nut is securely attached to the straight axle.
Assembly 5 Pedal Hub 9 Metal Tab Pedal Hubs Pedal Axle Metal Tab Slot Pedal Hub • Place two pedal hubs on the pedal axle so that the metal tabs on the pedal axle fit into the slots inside each pedal hub. • Push the pedal hubs in until they are flush with the surface of the front wheel.
Assembly 12 14 Fork Arms Gas Cap Pedal Axle Cover Groove Pedal Axle #8 x 3/4" Screw – 4 SHOWN ACTUAL SIZE • Place the front wheel assembly between the fork arms so that the pedal axle fits into the groove at the bottom of each fork arm. • Place a pedal axle cover over the pedal axle on one fork arm. • Insert two #8 x 3/4" screws into the pedal axle cover and tighten with a Phillips screwdriver. Do not over-tighten. • Repeat this procedure to attach the other pedal axle cover to the other fork arm.
Attaching the Seat Label Decoration Helpful Hint: The seat can be attached to the frame in any of three positions, depending on the size of your child. Check your child’s fit on the Grow-With-Me Trike by observing the seat to pedal distance, as it is being ridden. If the pedals seem too far away or too close for your child, move the seat up or down.
Removing the Seat Maintenance • Check the plastic parts regularly and if broken or cracked, dispose of them properly. • Check all fasteners regularly to be sure they are tight. If the fasteners are not tight, tighten them as necessary. • To clean the Grow-With-Me Trike, use a mild soap and water solution and a clean cloth. Rinse clean with water to remove soap residue. Seat Seat Retainer Tab Frame Seat Retainer Tab • Turn the frame on it’s side.