User Manual

ManualsBrandsFisher-Price ManualsInfant Gyms3-in-1 Convertible Car Gym

DFP07

fisher-price.com

Keep these instructions for future reference, as they contain important information.

Adult assembly is required.

Requires three, AA (LR6) alkaline batteries (not included).

Tool required for battery installation: Phillips screwdriver (not included).

Lay & Play

Tummy Time

Sit & Drive

WARNING

To prevent entanglement injury, never place the

gym in a crib or playpen. Never add strings,

ties or other products to the gym.

Summary of content (6 pages)

PAGE 1
DFP07 1 2 Lay & Play 3 Tummy Time Sit & Drive WARNING To prevent entanglement injury, never place the gym in a crib or playpen. Never add strings, ties or other products to the gym. Keep these instructions for future reference, as they contain important information. Adult assembly is required. Requires three, AA (LR6) alkaline batteries (not included). Tool required for battery installation: Phillips screwdriver (not included). fisher-price.
PAGE 2
Consumer Information FCC STATEMENT (UNITED STATES ONLY) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
Battery Installation Battery Safety Information In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbonzinc) or rechargeable (nickel-cadmium). • Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use. Always remove exhausted batteries from the product.
PAGE 4
Assembled Parts Permanent Assembly Arch 6 Hanging Toys Base Buttons Mat • Position each base so that the button is inward. • Insert and “snap” the ends of the arch into the socket in each base. Hint: The arch is designed to fit the bases one way. If it does not seem to fit, turn the arch around and try again. Or, reposition the bases so that the button is inward.
PAGE 5
Assembly and Setup Hang the toys from the loops around the gym. Insert the ends of straps on the side of the mat into the slots in the base. Pull up on the straps to be sure the mat is secure to the base. Repeat to assemble the straps on the other side of the mat to the base. Position the mat so that the end that is more upright is behind the steering wheel. Note: To machine wash the mat, from underneath the bases, push the straps up through the slots in the bases.
PAGE 6
Grows with Baby! Lift or Lower Arch Press the buttons on the inside of the frame to lift or lower the arch for each mode. • While pressing the buttons, lift the arch to the highest position. • Slide the mode switch on the upper arch to Lay & Play . • Listen to 30 minutes of music when baby bats toys hanging from the steering wheel. 1 Lay & Play • While pressing the buttons, lower the arch to the lowest position. • Slide the mode switch on the upper arch to Tummy Time .