| 77306pr-0820 ark 5/6/02 5:40 BM 3 1 Model Number 77306 Please keep this instruction sheet for future reference, as it contains important information. Requires four "C” (LR 14) alkaline batteries for control tower; four "AA" {LR} alkaline batteries for car; and ane 9V (BLURB) alkaline battery for remote controller (batteries not included), Adult assembly is required.
5/6/02 5:40 PM wr 4 Stadium Lights iy 2 Ramp Rails #6 x 5" Screw 2 Shown Actual Size Dag Double Flag Remote Controller Holder Tr Handle TEL By Handle Support / Remote Controller Ring of Fire Ramp 7 Crash Gate Flexible Track
5/6/02 5:40 PM re Battery Installation Tower Battery Compartment Door Car 1.8¥ x 4 “C" (LR) Shown Actual Size + Locate the battery compartment on the back of the tower, » Loosen the screws in the battery compartment door with a Phillips screwdriver, Remove the battery compartment door. * Insert four "C* (LR) alkaline batteries, as indicated inside the battery compartment. Replace the battery compartment door and tighten the screws with a Phillips screwdriver, Do not over-tighten, 1.
5/6/02 5:40 PM wr Battery Installation Remote Controller * Locate the battery compartment on the back of the remote controller. + Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door. Battery + Insert one SV (6L.R61) alkaline Compartment battery, as Indicated inside the Door battery compartment. * Replace the battery compare. Intersession commonsense? men door and tighten the screw with a Phillips screwdriver.
/85/02 5:40 PM 7 5 When To Replace Batteries if this toy is working slowly or erratically, it's likely that batteries need fo be replaced. While it is possible that afl batteries may need replacement, the batteries that will need replacement most often are the batteries in the car, followed by the remote controller, and then the control tower. For more information, see the troubleshooting guide beginning on page 19. Battery Tips + We recommend using alkaline batteries for longer battery life.
5/6/02 5:40 PM or 8 This product contains small parts in its assembled state. Adult assembly is required. Handle Handle Support * Fit the handle onto the handle support as shown. * Position the handle support so the pegs are facing you. * With the checkered side facing down, fit the double flag on to the pegs on the handle support. + Insert two screws through the holes in the handle and into the handle support. Tighten the screws with a Phillips screwdriver. Do not over-tighten.
5/6/02 5:40 PM 7 7 Remote Controller Holder * Insert and “snap” the tabs on * "Snap" the remote controller the handle and starting gate holder onto the tab on the bottom into the matching holes in the of the starting ramp, as shown. tower as shown, * Insert and “snap” the pegs on the bottom of the handle assembly into the matching holes in the starting ramp as shown.
5/6/02 5:40 insert and “snap” the tabs on the ramp into the matching slots in a ramp rail. + Repeat this procedure to attach the other ramp rail.
T7306pr-0520. gk Bobble 5:40 Label Decoration Proper label application will help keep labels looking their best! When applying labels, keep the following guidelines in mind: * Wash hands before applying labels. « Before applying labels, wipe the surface of the toy with a clean, dry cloth to remove dust or oils. *» For best results, avoid repositioning a label once it has been applied. + Apply labels as shown in the illustration. One time assembly is now complete.
5/6/02 5:41 BM sr ie Mode | Beginner Driver Mode 1 is for a beginner or younger driver. Automatic Course Gondolier always keeps the car hugging the track, even over obstacles. Just press the remote controller button to go and release fo stop. Setting Up The Track Hint: For best performance use this toy on a smooth, flat surface. We do not recommend use on a deep, pile carpet. This toy is designed for indoor use only.
5/6/02 5:41 Mode | Beginner Driver Dirt Track * Note the grooves on the edges of the crash gate, the ring of fire ramp and the dirt track. + Fit the grooves on these three obstacles onto the flexible track. Place the obstacles anywhere you like, but be sure to keep them on the outside of the track, as shown. Hint: For best performance, space the obstacles equally around the course, + Fit the four stadium lights anywhere onto the track. * Fit the two flags into any of the holes on the dirt track.
5/6/02 5:41 BM os 1z Mode | Beginner Driver Let’s Go + Locate the reset switch on the back of the control tower. * Slide the reset switch ON @, * Locate the ON/OFF bunion on the front of the control tower. * Press the ON/OFF bunion to turn the track and the control tower on, The button lights up if the track is properly connected! Hint: if the car hasn't driven past the control tower in a few minutes, the control tower turns off automatically and the control tower button light goes out.
Arrows + Note the arrows on the starting gate. Place rear wheels of the car on the starting gate, making sure the car is pointing in the same direction as the arrows. The car should move around the track counter-clockwise. Listen to the engine raving. 13 5/6/02 5:41 i 13 | Mode | Beginner Driver WARNING To prevent entanglement, keep hair away from wheels. * Press the forward button © on the remote controller.
5/6/02 5:41 PM sr 14 Mode Il Pro Driver Mode I is for a more experienced driver who has acquired better manual skills. In this mods, kids can take full control of steering and direction. For some challenging fun, your child can set up an off road course and use, the remote controller wheel to steer around obstacles. Setting Up The Track * For off-road fun, place the starting Speed Control Switch gate, dirt track, ring of fire or crash gate in any layout you like.
5/6/02 5:41 Turn the control tower power on to hear sound effects each time the car drives over the starting gate. * Be sure the reset switch on the control tower is set to the on position @, * Press the ON/OFF button on the front of the control tower to turn power on. The button lights up only if the track is connected. Hint: If the car hasn't driven past the control tower for a few minutes, the tower turns off automatically. Press the ON/OFF button again for power.
5/6/02 S:41 PM Sed is + Lift the control tower storage compartment door, * Place the barrels, cones, hay bales, and road flags into the control tower. Close the door. + Slide the track over the starting gate. * Remove the flexible track from both sides of the control tower.
5/6/02 £:41 PH wy 17 Storage Fire Ramp * Fit the dirt track to the crash gate as shown, « Fold the ring of fire down onto the ramp. « Fit the ring of fora ramp onto the dirt track as shown. + Slide the edges of the dint track into the grooves in the handle support and control tower. + Attach the car to the hook on the handle support as shown.
5/6/02 5:41 PM re TTT ECT * Keep the car res clean for best performance. * Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do not immerse this toy. + This toy has no consumer serviceable parts. Do not take this toy apart. * Do not drop this toy on a hard surface, * Fit the stadium lights onto the track as shown, » Place the remote controller in the holder as shown.
5/6/02 5:41 double Shooting Guide Car moves vary slowly * Battery power in the car may be weak. Replace all four batteries with fresh, alkaline batteries, + The wheels may be dirty. Wipe them with a clean cloth dampened with a mild soap and water solution.
S/6/02 5:41 FM sa 20 double Shooting Guide Car does not respond to the remote controller The car mode switch may be sel to off O. Ba sure the mode button on the car is either set to Lor if, The power indicator on the car is off, and the car may have fumed off automatically. Press the ON/OFF button on the car again. The button should light up. If the ON/OFF button on the car is fit, battery power in the remote controller may be weak.
5/6/02 5:41 DM Si 21 double Shooting Guide Car keeps sliding in the turns . Try reducing speed in the turns by releasing the remote controller bunion. Set the car to the low speed setting or Be sure the flexible track layout does not have sharp bends. Try an oval, or Kidney or other curved shape. The wheels may be dirty. Wipe them with a clean cloth dampened with a mild soap and water solution. Do not immerse the car.
5/6/02 5:41 BM wr 22 One (1) Year Limited Warranty Fisher-Price, Inc., 636 Gerard Avenue, East Aurora, New York 14052, warrants that "Grow with Me™ RC Rally” is free from all defects in material and workmanship when used under normal conditions for a period of ane (1) year from the date or purchase. Should the product fail to perform properly, we will repair or replace it at our option, free of charge.
EMC Compliance UNITED STATES: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, not installed and used in accordance with the instructions, may cause Armful interference 10 radio communications.
5/5/02 5:41 BM So 4 Consumer Information Questions? We'd like to hear from you! Call Fisher-Price® Consumer Relations, toil-free at 1-800-432-KIDS, EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470. Or, write to: Fisher-Price® Consumer Relations, 836 Gerard Avenue, East Aurora, New York 14052.