Installation Guide

Installing Trim Kit
1. Cut opening in the cabinet face per the following dimensions:
Height: 17” + 1/16”, –0
Width: 24-3/4” + 1/16”, –0
Note: Refer to diagram on the following page.
The minimum cabinet depth is 20”.
When installing the Microwave and Trim Kit in
combination with a Wall Oven or Warming Drawer,
follow the recommendations in the Microwave
Installation/ Use & Care Manual.
2. Add adequate platform base support in the bottom
of the cabinet for trim kit base to rest on.
3. Mark a centerline on the front edge of the cabinet
bottom (Fig. 01).
4. Place trim kit base and align centerline mark to the
triangular notch on the front edge of the base (Fig. 02).
5. Drill 1/8” pilot holes in the cabinet using the base as a
template and install a screw through the base into the
cabinet bottom to prevent the base from shifting (Fig. 03).
6. Insert Microwave into opening on top of the base.
The Microwave feet should sit in the recesses on the base
for correct alignment. The Microwave should be plugged
in at this point.
Before you begin, read these instructions completely and carefully.
Getting Started
Remove packaging
Contents Tools Required
Part Description Qty
Trim Assembly 1
Base 1
Mounting Bracket (L/R) 2
Sheet Metal Screws 10
Fig. 01
Fig. 02
Fig. 03
1/8” Drill
#2 Phillip Screwdriver
MODEL MOTTK30 TRADITIONAL MICROWAVE TRIM KIT
INSTALLATION INSTRUCTIONS