Installation guide

7
6 CUSTOM DRAWER PANEL SPECIFICATIONS
The following calculations assume the top of the upper panel is
aligned with the top of the adjacent cabinetry.
The final panel/cabinetry alignment is achieved by adjusting the feet:
WIDTH OF ALL PANELS
Measure A (the width between adjacent door/drawer fronts)
and write it in the first box below, then complete the equation.
HEIGHT OF THE UPPER PANEL
HEIGHT OF THE LOWER PANEL
Measure C (door/drawer height (or equivalent)) and write it in the
first box below, then complete the equation.
min. 1/16”
(2mm)
Ventilation Gap
(min. 5/16” (8mm))
min. 1/16” (2mm)min. 1/16” (2mm)
min. 1/16” (2mm)
WIDTH OF ALL PANELS
UPPER PANEL
LOWER PANEL
TOEKICK PANEL
HEIGHT OF
LOWER PANEL
HEIGHT OF
UPPER PANEL
C
A
B
A
B
C
Clearance to adjacent
cabinet front
(min. 1/16” (2mm))
(0”/0mm recommended)
(min. 12 1/4” (311mm))
(min. 5/16” (8mm))
(23 7/16”-24 3/16” (596-615mm))
Height of
Upper Panel
Upper Panel extension
Ventilation Gap
Minimum height
DD24DI models:
DD24DTI/DD24DHTI models:
(min 28 1/4” (717mm) +
B)
(min 30” (762mm) +
B)
DD24DI models:
DD24DTI/DD24DHTI models:
WIDTH OF PANEL
HEIGHT OF
UPPER PANEL
HEIGHT OF
LOWER PANEL
15 11/16”
17 3/8”
(398mm)
(442mm)
Note: The ‘upper panel extension’ B allows for the top of the upper
panel to extend above the chassis where required, however a
min. 1/16” (2mm) gap to the countertop must be maintained.
Note: The ‘upper panel extension’ B
allows for the top of the upper panel to
extend above the chassis where required,
however a min. 1/16” (2mm) gap to
the countertop must be maintained.
- 2x =
=
=
+
--
FRONT PANEL MATERIAL SPECIFICATIONS
●
5/8 - 13/16” (16 - 20mm) panel thickness.
●
Adequately sealed to withstand moisture (122
O
F/50
O
C @ 80% RH)
Because of it being a hot and wet environment generally, the back and sides of the
panel should be completely sealed with a waterproof vapor barrier (ie polyurethane)
to prevent damage to the panel.
●
The back of the panel (including any integrated handle) should be completely flush
so that the seal between the panel and the rubber trim is maintained.
●
Installation outside these specs may result in condensation on cabinetry surfaces.
●
Maximum weight of each panel: 20lb (9kg)