Quick Start Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
19
!4CONNECT TO WATER AND POWER SUPPLY
F
A
WARNING!
The water connection instructions below are intended only for the professional
installer.
WARNING—connect to potable drinkable water supply only.
DO NOT install on line pressure above 120psi (827kPa) or below 22psi (150kPa).
DO NOT use on hot water supply (100°F [38°C max.]).
1 Flush water through the hose prior to connection to the
appliance to remove any debris in the hose.
2 Move the appliance in front of the cabinetry close
enough that you can access behind for power and water
connections.
3 Connect a braided water hose to the water supply valve
(A), and insert the free end of the hose through a hole
at the rear of the plinth (B).
4 Push the hose all the way to the front and connect a
brass adaptor (C).
Note: The adaptor is not required for installation if (1/4”)
6.35mm PEX plastic tubing (optional) is used.
5 Insert the tube end of the adaptor fully into the PRV (D).
6 Secure the connection with a locking clip between the
PRV and hose end of the adaptor (E).
7 At the back of your appliance, connect the power cable
to the power supply (115VAC, 60Hz) (F).
– You will hear a chime sound when the appliance is
powered on and automatically goes into ‘Installer
(standby) mode’.
– Refer to ‘User guide’ for more details on activating
the appliance.
8 Check the connection and open the water supply to test
for leaks.
Note:
The water supply connection is only used for freezer
models.
For dual installation, follow the instructions above for
both first and second appliances.
IMPORTANT!
Old water fittings (hose-sets) should not be reused.
The appliance includes a stainless braided water
line hose.
The shut off valve should be accessible.
Make sure each appliance is connected to a
separate power outlet.
Required components/tools:
water filter installation kit (847678)
– 2x collet locking clip (837193)
– 1x 1/4” (6mm) brass adaptor (841679)
– 1x 1/4” (6mm) comp. Stainless steel
braided hose (841651)
– 1x adaptor tube (312198)
C
D
E
B
rear view from
back of appliance