Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Components
- 3 Tools
- 4 Appliance and cavity dimensions
- 5 Cabinetry options
- 6 Stainless steel door panel and toe kick dimensions
- 7 Custom door panel and toe kick dimensions
- 8 Custom door panel installation dimensions
- 9 Custom door panel installation template
- 10 Door clearance
- 11 Electrical and plumbing
- 12 Before installation
- 13 Cavity preparation
- 14 Water and power supply connection
- 15 Top trim installation
- 17 Positioning into cabinetry
- 18 Aligning inside cabinetry
- 19 Door panel installation - stainless steel
- 20 Door panel installation - custom
- 21 Fixing to cabinetry
- 22 Water filter installation
- 23 Toe kick installation
- 24 Door and door trims installation
- 25 Cabinet trims installation — [A] Flexible spring clip method
- 26 Cabinet trims installation — [B] Fixed screw method
- 27 Final checklist
- 1 Consignes de sécurité et mises en garde
- 2 Pièces
- 3 Outils
- 4 Dimensions de l’appareil et de la cavité
- 5 Options d’armoires
- 6 Dimensions de panneau de porte et de plinthe en acier inoxydable
- 7 Dimensions de panneau de porte et de plinthe sur mesure
- 8 Dimensions d’installation de panneau de porte sur mesure
- 9 Gabarit D'installation de panneau de porte sur mesure
- 10 Dégagement de la porte
- 11 Raccordement électrique et plomberie
- 12 Avant l’installation
- 13 Préparation de la cavité
- 14 Alimentation en eau et alimentation électrique
- 15 Installation de la garniture supérieure
- 17 Positionnement dans les armoires
- 18 Alignement dans les armoires
- 19 Installation de panneau de porte — En acier inoxydable
- 20 Installation de panneau de porte — Sur mesure
- 21 Fixation aux armoires
- 22 Installation du filtre à eau
- 23 Installation de la plinthe
- 24 Installation des garnitures de porte et tiroir
- 25 Installation des garnitures de bâti — [A] Méthode avec clip de fixation flexible
- 26 Installation des garnitures de bâti — [B] Méthode avec vis fixée
- 27 Liste de vérification
16
IMPORTANT!
The appliance has front and rear rollers for moving the appliance forward and backward.
Do not move the appliance sideways to avoid damaging the rollers or the floor
covering/surface.
The appliance must be installed by a qualified installer, or Fisher & Paykel trained and
supported service technician to avoid faulty electrical connection and water leaks.
All connections for water, electrical power and grounding must comply with local codes
and ordinances and be made by licensed personnel when required.
Avoid installation of the appliance/s under a ground fault circuit interrupter (GFCI).
Ensure the appliance is installed properly. Improper installation that results in appliance
failure is not covered under the appliance warranty.
Check installation location
1
Check the cabinetry
– Check the dimensions — height, width, depth, floor level,
finishedalcovereturns.
– Ensure that the ventilation openings in the cabinetry are clear of obstruction.
– For integrated installation, a finished return of solid material is required
across the top and sides of the new or existing alcove.
– Refer to the ‘Cavity Dimensions’ table prior to installation of the appliance.
2
Check the power supply
– Ensure that there is a separate power outlet for the appliance.
– Avoid sharing the power point with other appliances to prevent the
appliancefrom accidentally switching off.
– For power requirements, refer to the information on the serial plate.
This is located at the front right-hand side of the drawer when open.
– Ensure your appliance is properly grounded (earthed).
– Connect the appliance to the electrical supply (115VAC, 60Hz) with fitted
plugand lead.
– We recommend to use an isolating switch that is easily accessible to the
userafter the appliance is installed.
– Follow the National Electrical Code and all local codes and ordinances
wheninstalling this appliance.
3
Check the water supply (for Ice and Water models only)
– Ensure that there is a separate water supply connection for the appliance.
– Your appliance must be installed by a qualified appliance installer as
incorrect plumbing can lead to water leaks.
– Fisher & Paykel is not liable for damage (including water damage) caused
byfaulty installation or plumbing.
!2BEFORE INSTALLATION